what is this error i mean what is the faults ?
nterface: UFI High-Speed
Serial number: 0011-8840-3467
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test... Done.
Init bus...
VCC: 3.3 V, VCCQ: 3.0 V
Bus: 8 bit (HS SDR 24MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x90 (SK Hynix)
Product name: H4G1d (0x483447316404), rev: 0x05, serial number: 0x01A10805
Manufacturing date: May 2014
CID: 90014A48 34473164 040501A1 08055144
CSD: D0270132 0F5903FF FFFFFFEF 8A4040D2
EXT_CSD revision: 1.6 (MMC v4.5, v4.51)
Partition info:
Boot1: 4096 KiB
Boot2: 4096 KiB
RPMB: 4096 KiB
User area: 3.64 GiB(3,909,091,328 bytes)
Writing preloader header... Done.
Current partition access:
Access to boot partition 1
Writing PRELOADER at 0x00000000 (222 sectors)... Done in 0.020 s
Writing boot partition config to 0x48... Done.
Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!
CMD1 error, cmd response: 0x40FF8080, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.