- Jun 10, 2019
- 1,324
- 907
ONEPLUS 7T FRP RESET DONE
Device : OnePlus 7T
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
SAMSUNG : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL DOWN + POWER on phone more than 3 times rapidly and then leave EDL Cable Button.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM63)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.3.5
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1500A00 [SD855] 85495100
OPK_DATA : 7A44FD44C35394DC10E1B910D525491DA862D0E420FE0BEF040FECF30032DA08
Initializing Protocol...OK
Using Pre-Defined Loader [OP_7T.ufl]
Preparing Loader...Done
Sending Loader [OP_7T]...Done
Executing Loader...OK
Detecting Storage Type...OK
Hardware : SD855, UFS, 256 GB
LU Count : 6 [0x03A90800] [0x00000800] [0x00000800] [0x00002000] [0x00100000] [0x00002000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 262144 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Software : , 1909250940 [Wed Sep 25 21:54:29 CST 2019]
Android Ver. : 10
Patch Level : 2019-09-05
Resetting FRP Lock...Failed
Using Patch Method... Done Done
Operation Finished.
QcFire Ver. 9.0
If you find my post helpful, press the like button✌
