DTPro Xiaomi Redmi 13C (Gale) New Sec Supported for preloader Auth! Writing Firmware Ok!...

[DTPRO Tool]

How to put your Device in BROM Mode!..
• please turn off your device and Unplug the USB Cable
• press the 2 Volume Buttons and Without Releasing them Connect USB Cable!...


Waiting for MTK Preloader connection...
Port name : MediaTek PreLoader USB VCOM_V1632 (Android) (COM10)
Connecting to comport... OK
Handshaking... OK
Reading SOCID... OK
Searching DA... OK
Reading target config... OK
Reading hw/sw ver... OK
HWID : 8A00_CA00_0000
Bypassing checksum mismatch for 1st DA... OK
Reading hw/sw ver... OK
HWID : 8A00_CA00_0000
Reading target config... OK
Reading bl ver... OK
Reading get ver... OK
Reading meid... OK
MEID : 6e50bec67e4241815115c35c516fb4c2
Sending 1st DA... OK
Jumping 1st DA... OK
Sending sync signal... OK
Sending device environment... OK
Starting hw init params... OK
Checking connection agent...PRELOADER
Sending 2nd DA... OK
Bypassing RSP... OK
Switching full-speed... OK OK
Storage : EMMC
Boot1 size : 0x400000
Boot2 size : 0x400000
Rpmb size : 0x400000
Userarea size : 0x1d1ec00000
SRAM size : 0x70000
DRAM size : 0x100000000
Reading Partition table... OK
Check scatter file... OK
Start Download Information... OK
Checking SGPT... OK
Checking PGPT... OK
Writing preloader... OK
Writing preloader_backup... OK
Writing vbmeta_a... OK
Writing vbmeta_system_a... OK
Writing vbmeta_vendor_a... OK
Writing md1img_a... OK
Writing spmfw_a... OK
Writing scp_a... OK
Writing sspm_a... OK
Writing gz_a... OK
Writing lk_a... OK
Writing boot_a... OK
Writing dtbo_a... OK
Writing tee_a... OK
Writing efuse... OK
Writing logo_a... OK
Writing logo_b... OK
Writing rescue... OK
Writing super... OK
Writing userdata... OK
Make Optional Download Act... OK
Rebooting... OK