UMT Tecno Spark Go(BF7) after frp tool DL fail error

[omtelecom25]

USING PL_EXLOIT [INFINIX V4]
Brand/Model : *Auto* / *Auto Detect*
Operation : Reset FRP
BOOT CFG : [PL_EXPLOIT : ON]
Waiting for Device...Found
Port : MediaTek PreLoader USB VCOM_V2023 (Android) (COM14)
Device Path : \\?\usb#vid_0e8d&pid_2000#6&10c694e1&0&1#{a5dcbf10-6530-11d2-901f-00c04fb951ed}
Driver : MediaTek Inc., 3.0.1512.0 [usb2ser_mtk.sys]
Mode : PRELOADER
Hw ID : MT6761 [0717] Helio A20/P22/A22/A25/G25
Details : 8A00,CA01,0200
Sec. Config : [SBA:True] [SLA:False] [DAA:True]
MEID : 9B11BBE2FCCF373345E543229B6337D6
SoC ID[0] : AC3F4B366AA448F2E0D1B1CF050D8DF2
SoC ID[1] : 4BAB14D60AC679161FDFB65C1AA07CEC
Using Internal DA!
Sending 1st DA..OK
Jump DA Address...OK
Syncing...OK
Checksum Level is Storage
Connection : preloader
Speed : HIGH-SPEED
Reading RAM Configuration...OK
Sending 2nd DA...OK
HRID : 85423F90328FDA781D33547312D68423
Int. RAM : 0x000000000003A600 [233.50 KB]
Ext. RAM : 0x00000000C0000000 [3.00 GB]
Flash ID : MMC32G
CID : D62D004D4D433332475102098B244A37
BOOT1 : 0x0000000000400000 [4.00 MB]
BOOT2 : 0x0000000000400000 [4.00 MB]
RPMB : 0x0000000000400000 [4.00 MB]
USERAREA : 0x0000000747C00000 [29.12 GB]
PRE EOL : NORMAL
Life. Est.A : 10%-20% LIFE TIME USED
Life. Est.B : 10%-20% LIFE TIME USED
Reading Partition Table...OK
And. Ver. : 12
Build Dt. : Fri Oct 11 23:53:46 CST 2024
Display ID : TECNO-S-64-241011V1719
Ver. Inc. : 241011V2347
Locale : en-US
Patch : 2024-10-05
Bootloader : LOCKED
Resetting FRP...OK
Operation Finished.
[UltimateMTK2 v1.8.1]

what is the solution in UMT, there is no command line for "tool DL image fail error"

 

[mian.sajid]

Load flash file and write only cash job done.