UMT Samsung S23 Ultra 5G SM-S918B Bit 3 lost mode done

UMT Box

deni29

Active Member
Oct 21, 2019
42
8
Device : Samsung Galaxy S23 Ultra 5G (SM-S918B) U3
Operation : Samsung Lost Mode Reset
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
SAMSUNG : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL DOWN + POWER on phone more than 3 times rapidly and then leave EDL Cable Button.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM23)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.5.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...Done
Protocol v3 or higher detected. Auto Loader unsupported.
Initializing Protocol...OK
Using Pre-Defined Loader [SMS918B_U3.ufl]
Preparing Loader...Done
Sending Loader [SMS918B_U3]...Done
Executing Loader...OK
Detecting Storage Type...OK
Hardware : , UFS, 256 GB
LU Count : 6 [0x03B64000] [0x00001400] [0x00001400] [0x00002000] [0x00028000] [0x00002000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 262144 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK [Sign]
Build : S918BXXS3BWKC
Int. Build : SM-S918B_EUR_XX_QKEY1
Resetting Lost Mode... Done Done Done
Once phone reboot in Odin Mode, full flash your device.
If stuck on Charging Logo, hold VOL DOWN + PWR for 5 Seconds.
Operation Finished.
 
Top