* Remove FRP Huawei Y7 Prime 2019 [DUB-LX1 8.2.0.188(C185)] 8.1 by UMT *
* Remove FRP Huawei Y7 Prime 2019 [DUB-LX1 8.2.0.188(C185)] 8.1 by UMT *
Code:
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM24)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1A00900 [8953] 65001500
OPK_DATA : 3B48AE9023196AE5C8162BCE65CB66E9636C784CB52A55046D15110FD8B11688
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8953_030]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8953, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : unknown
Software : System 8.2.0.036(1RUM) [Mon Dec 7 22:38:45 CST 2020]
Android Ver. : 8.1.0
Patch Level : 2020-09-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 5.7