Redmi Note5 Mi Account Removed Done

SamarMobileZone

Junior Member
Jun 5, 2018
3
1
Karachi
Skype
[email protected]
Sonork ID
100.1652602
Operation : Disable Mi Account
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM105)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 5.1.1.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_016]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 5 [whyred]
Brand : xiaomi
Prod.Name : whyred
Software : PKQ1.180904.001, V11.0.3.0.PEIMIXM [Fri Nov 8 00:14:51 WIB 2019]
Android Ver. : 9
Patch Level : 2019-11-05
Reading Data...
Preparing Data...Done
Trying to Disable Mi Account...Done
Operation Finished.
QcFire Ver. 6.0
 

hacker32

Member
Jun 18, 2018
5
3
Abidjan
Operation : Reset Mi Account
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM6)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_016]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 5 [whyred]
Brand : xiaomi
Prod.Name : whyred
Software : PKQ1.180904.001, V11.0.3.0.PEIMIXM [Fri Nov 8 00:14:51 WIB 2019]
Android Ver. : 9
Patch Level : 2019-11-05
Resetting Mi Account Data...Done
Preparing Data...Done
Formatting Userdata...Done
When phone is completely ON, connect to Internet and add Mi Account.
-------------- INFORMATION --------------
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.
QcFire Ver. 6.2
 
Top