hi every body, today i Did FRP reset for a Redmi (Ice/snow)
1 st Put phone in fastboot mode and read info
2 nd:
FRP Erase Lock/Direct
Done.
1 st Put phone in fastboot mode and read info
11/27/2022 11:50:49 AM - Initializing..
11/27/2022 11:50:49 AM - Check If Phone is Connected..
11/27/2022 11:50:50 AM - Comunicating..
11/27/2022 11:50:50 AM - Model : snow
11/27/2022 11:50:50 AM - Baseband : MOLY.LR12A.R3.MP.V219.3.P12
11/27/2022 11:50:50 AM - Variant :
11/27/2022 11:50:50 AM - CPU ID : 3c6709ed16ca8ae3b953673e9e6286b3c13803b0
11/27/2022 11:50:50 AM - Warranty : yes
11/27/2022 11:50:50 AM - Sec Info : yes
11/27/2022 11:50:50 AM - Serial : W8EQR86TVCHY5LIF
11/27/2022 11:50:50 AM - Voltage : 4331mV
11/27/2022 11:50:51 AM - Bootloader : ice-1837361bf-20220728152517-20220823223454
11/27/2022 11:50:51 AM - Bootloader Status : no
11/27/2022 11:50:51 AM - Done..
2 nd:
FRP Erase Lock/Direct
11/27/2022 12:01:14 PM - Operation : Direct Frp erase
11/27/2022 12:01:15 PM - MTK Flash/Exploit Client V1.6.0 (c) B.Kerler 2018-2022
Preloader - Status: Waiting for PreLoader VCOM, please connect mobile
11/27/2022 12:01:17 PM -
Port - Hint:
Power off the phone before connecting.
For brom mode, press and hold vol up, vol dwn, or all hw buttons and connect usb.
For preloader mode, don't press any hw button and connect usb.
If it is already connected and on, hold power for 10 seconds to reset.
11/27/2022 12:01:17 PM -
11/27/2022 12:01:19 PM - .
11/27/2022 12:01:19 PM - .
11/27/2022 12:01:19 PM - .
11/27/2022 12:01:20 PM - .
11/27/2022 12:01:20 PM - .
11/27/2022 12:01:20 PM - .
11/27/2022 12:01:20 PM - .
11/27/2022 12:01:21 PM - .
11/27/2022 12:01:21 PM - .
11/27/2022 12:01:21 PM - .
11/27/2022 12:01:22 PM - .
11/27/2022 12:01:23 PM - Port - Device detected
Preloader - CPU: MT6761/MT6762/MT3369/MT8766B(Helio A20/P22/A22/A25/G25)
Preloader - HW version: 0x0
Preloader - WDT: 0x10007000
Preloader - Uart: 0x11002000
Preloader - Brom payload addr: 0x100a00
Preloader - DA payload addr: 0x201000
Preloader - CQ_DMA addr: 0x10212000
Preloader - Var1: 0x25
Preloader - Disabling Watchdog...
Preloader - HW code: 0x717
Preloader - Target config: 0xe7
Preloader - SBC enabled: True
Preloader - SLA enabled: True
Preloader - DAA enabled: True
Preloader - SWJTAG enabled: True
Preloader - EPP_PARAM at 0x600 after EMMC_BOOT/SDMMC_BOOT: False
Preloader - Root cert required: False
Preloader - Mem read auth: True
Preloader - Mem write auth: True
Preloader - Cmd 0xC8 blocked: True
Preloader - Get Target info
Preloader - BROM mode detected.
11/27/2022 12:01:23 PM - Preloader - HW subcode: 0x8a00
Preloader - HW Ver: 0xca01
Preloader - SW Ver: 0x200
Preloader - ME_ID: B72698DF6D0B1F0A564FE1796B41150F
Preloader - SOC_ID: F1825C479A5C0D072093ED46A7D0160C026217A69E39829FB6A78EFEF847AAA8
PLTools - Loading payload from mt6761_payload.bin, 0x264 bytes
PLTools - Kamakiri / DA Run
Kamakiri - Trying kamakiri2..
11/27/2022 12:01:23 PM - Kamakiri - Done sending payload...
11/27/2022 12:01:23 PM - PLTools - Successfully sent payload: C:\DTPRO\New_Mediatek_v4.0.0.000041EXT_rev1\File\mtkclient\payloads\mt6761_payload.bin
Port - Device detected
DA_handler - Device is protected.
DA_handler - Device is in BROM mode. Trying to dump preloader.
11/27/2022 12:01:26 PM - Successfully extracted preloader for this device to: preloader_ice.bin
DAXFlash - Uploading xflash stage 1 from MTK_AllInOne_DA_5.2152.bin
xflashext - Patching da1 ...
Mtk - Patched "Patched loader msg" in preloader
xflashext
xflashext - [LIB]: [33mError on patching da1 version check...[0m
Mtk - Patched "Patched loader msg" in preloader
Mtk - Patched "get_vfy_policy" in preloader
xflashext - Patching da2 ...
11/27/2022 12:01:27 PM - DAXFlash - Successfully uploaded stage 1, jumping ..
Preloader - Jumping to 0x200000
Preloader - Jumping to 0x200000: ok.
11/27/2022 12:01:28 PM - DAXFlash - Successfully received DA sync
11/27/2022 12:01:28 PM - DAXFlash - DRAM config needed for : 9b01005932503033
DAXFlash - Sending emi data ...
11/27/2022 12:01:28 PM - DAXFlash - DRAM setup passed.
DAXFlash - Sending emi data succeeded.
DAXFlash - Uploading stage 2...
11/27/2022 12:01:30 PM - DAXFlash - Upload data was accepted. Jumping to stage 2...
11/27/2022 12:01:30 PM - DAXFlash - Successfully uploaded stage 2
DAXFlash - EMMC FWVer: 0x0
DAXFlash - EMMC ID: Y2P032
DAXFlash - EMMC CID: 9b010059325030333200c13803b039b3
DAXFlash - EMMC Boot1 Size: 0x400000
DAXFlash - EMMC Boot2 Size: 0x400000
DAXFlash - EMMC GP1 Size: 0x0
DAXFlash - EMMC GP2 Size: 0x0
DAXFlash - EMMC GP3 Size: 0x0
DAXFlash - EMMC GP4 Size: 0x0
DAXFlash - EMMC RPMB Size: 0x1000000
DAXFlash - EMMC USER Size: 0x747c00000
DAXFlash - HW-CODE : 0x717
DAXFlash - HWSUB-CODE : 0x8A00
DAXFlash - HW-VERSION : 0xCA01
DAXFlash - SW-VERSION : 0x200
DAXFlash - CHIP-EVOLUTION : 0x0
11/27/2022 12:01:31 PM - DAXFlash - DA-VERSION : 1.0
11/27/2022 12:01:31 PM - DAXFlash - Upload data was accepted. Jumping to stage 2...
11/27/2022 12:01:31 PM - DAXFlash - DA Extensions successfully added
11/27/2022 12:01:31 PM - DAXFlash - Formatting addr 0x24408000 with length 0x100000, please standby....
Done |--------------------------------------------------| 0.0% Erasing (Sector 0x0 of 0x800) 0.00 MB/s
11/27/2022 12:01:31 PM -
Progress: |GûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûêGûê| 100.0% Erasing (Sector 0x800 of 0x800, ) 7.25 MB/s
DAXFlash - Successsfully formatted addr 0x24408000 with length 1048576.
Formatted sector 1187904 with sector count 2048.
11/27/2022 12:01:32 PM - Frp lock Zone formated | Frp erase done!
Done.