nokia ta-1083frp done by umt

[vicky_tomar]

Device : Nokia TA-1083
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM100)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : 2F69871CD490AF7CD743D2D97DB3E11DD1B3B722B5F896699F2916A09FA2DFF2
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_023]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : FIH GSI-00WW [DRG_sprout]
Software : 00WW_3_54J, 00WW_3_54J [Tue Jul 23 15:44:00 CST 2019]
Android Ver. : 9
Patch Level : 2019-08-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 4.9.1