UMT Huawei Y7 Prime 2019 frp done with umt qcfire.

UMT Box

adil469

Active Member
Jul 12, 2017
32
11
karachi pakistan
Device : Huawei Y7 Prime 2019 (LDN-L21)
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM19)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.0.3
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1F00400 [8937] 41001500
OPK_DATA : 3B48AE9023196AE5C8162BCE65CB66E9636C784CB52A55046D15110FD8B11688
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8937_034]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, EMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : unknown
Software : System 8.0.0.073(091T), eng.jenkin.20200225.181227 [Tue Feb 25 18:12:27 CST 2020]
Android Ver. : 8.0.0
Patch Level : 2020-02-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 6.9
 
Top