Welcome to Octoplus Huawei Software v.1.3.5.1
To enable 'Manufacture' mode dial
- for Qualcomm and Hisilicon based models: *#*#2846579#*#*
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode
- for MTK based models: *#*#14789632#*#*
ProjectMenu > Background Settings > USB Port Settings > Debug Mode
To enable 'Fastboot' mode
1. Power off the phone. Remove SD and SIM cards
2. Press 'Vol-' and insert USB cable
3. Wait until phone enters 'Fastboot' mode
To enable 'Upgrade' mode
1. Power off the phone. Remove SD and SIM cards
2. Press and hold 'Vol-' and 'Vol+' keys and insert USB cable
3. Wait until phone enters 'Upgrade mode'
Found COM ports:
1: COM1 通信端口
Job ID: 000000000214EFA9
2024-12-28 07:15:00
Starting Direct Unlock
Selected phone model: LIO-AN00
Selected method: Direct Unlock (EMUI12/Harmony)
Warning: Please, make sure the phone`s battery is fully charged and connected, after connect the device via Factory Mode (use Hardware Test Point or "ON/OFF Factory Mode option").
Warning: Selected response: Proceed
Searching HUAWEI USB COM 1.0 port...
Detected HUAWEI USB COM 1.0 port
Phone connect successfully
Writing bootloader KIRIN990_5G_V5...
Initializing remote service connection...
Writing XLOADER partition...
Writing UCE partition...
Writing FASTBOOT partition...
Writing BL2 partition...
Operation in progress. Please wait for instructions...
Bootloader Update successfully
Rebooting to fastboot mode...
Warning: If you use modified USB cable please reconnect cable from the mother board and press "Ok" to proceed the operation
Warning: Selected response: Ok
Searching Fastboot devices...
Error: Fastboot devices not found
Direct Unlock failed.
Performed by 1.3.5.1 Software version.
