Chimera Help! M336K BIT 7 FRP EUB done but stuck logo

[buolmobi]

Help M336K BIT 7 FRP EUB done but stuck logo
Thanks

Printing phone history
FRP Remove
Successfully finished.
Finished at local time: [08.21.24 11:17:47]
WorkID: 299888849

Please login to view image

 

[ChimeraTool]

Help M336K BIT 7 FRP EUB done but stuck logo
Thanks

Printing phone history
FRP Remove
Successfully finished.
Finished at local time: [08.21.24 11:17:47]
WorkID: 299888849

View attachment 68810

Dear User,

I have looked into your works and it looks like the drivers are not functioning properly on your computer.
To resolve this, first make sure you are using a stock/full copy of Windows 10, update it to the latest patch, install/reinstall all Chimera drivers and restart the PC after you are done.
Also note, that A33 models have a unique motherboard construction that makes them especially sensitive when shorting the test points, and it is very easy to brick the device if the batteries are reconnected AFTER the USB is plugged in. Please make sure to reconnect the batteries BEFORE you plug in the USB and short the test points, just as it's shown in this video

Best Regards,
ChimeraTeam

 

[buolmobi]

Dear User,

I have looked into your works and it looks like the drivers are not functioning properly on your computer.
To resolve this, first make sure you are using a stock/full copy of Windows 10, update it to the latest patch, install/reinstall all Chimera drivers and restart the PC after you are done.
Also note, that A33 models have a unique motherboard construction that makes them especially sensitive when shorting the test points, and it is very easy to brick the device if the batteries are reconnected AFTER the USB is plugged in. Please make sure to reconnect the batteries BEFORE you plug in the USB and short the test points, just as it's shown in this video

Best Regards,
ChimeraTeam

yes, I have done many M336K without logo hang, only this M336K FRP successfully rebooted and logo hang
Or the mainboard has been repaired so the logo is stuck
do you have any way to fix this?

 

[ChimeraTool]

yes, I have done many M336K without logo hang, only this M336K FRP successfully rebooted and logo hang
Or the mainboard has been repaired so the logo is stuck
do you have any way to fix this?

Dear User,

Connect the device in EUB mode, and perform a Repair Boot procedure.
After that, flash it with a stock firmware.
You can also try to use a different cable and/or computer, and just quickly go through the steps required to ensure your drivers are functioning properly, if the suggestions above did not help.

Best Regards,
ChimeraTeam