hi sir . pls help on my Huawei CUN-U29 dead when i recieve .i cant find isp pin out on internet so i remove the emmc from the board and put it in ic friend and flashed firmware .Success fashing but the the phone wont turn on.
here is the logs
pls help on how to solve .Thank you
here is the logs
Operation: Write by vendor (MediaTek)
Partition name: PRELOADER
Filename: preloader_hq6582_we_b1b_l1.bin , Offset: 000000000000 , filesize: 123104 bytes
eMMC switching to ROM2
Erasing partition...
Writing partition...
Done writing partition. Write speed: 326.39 KB/s
Partition name: MBR
Filename: MBR , Offset: 000001400000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 47.32 KB/s
Partition name: EBR1
Filename: EBR1 , Offset: 000001480000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 57.96 KB/s
Partition name: UBOOT
Filename: lk.bin , Offset: 000007120000 , filesize: 417552 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 382.90 KB/s
Partition name: BOOTIMG
Filename: boot.img , Offset: 0000071A0000 , filesize: 4808704 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 771.06 KB/s
Partition name: RECOVERY
Filename: recovery.img , Offset: 0000077A0000 , filesize: 5685248 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 764.53 KB/s
Partition name: SEC_RO
Filename: secro.img , Offset: 000007DA0000 , filesize: 135168 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 577.82 KB/s
Partition name: LOGO
Filename: logo.bin , Offset: 000008420000 , filesize: 909312 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 690.56 KB/s
Partition name: EBR2
Filename: EBR2 , Offset: 000008720000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 94.77 KB/s
Partition name: FRP
Filename: frp.bin , Offset: 0000091A0000 , filesize: 1048576 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 768.51 KB/s
Partition name: ANDROID
Filename: system.img , Offset: 000009800000 , filesize: 2474639360 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 775.54 KB/s
Partition name: CUST
Filename: cust.img , Offset: 00009D000000 , filesize: 419430400 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 776.45 KB/s
Partition name: CACHE
Filename: cache.img , Offset: 0000B6000000 , filesize: 5529820 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Sparse image found v.1.0 Total chunks: 16
Done writing partition. Write speed: 770.27 KB/s
Partition name: USRDATA
Filename: userdata.img , Offset: 0000BF600000 , filesize: 75408588 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Sparse image found v.1.0 Total chunks: 100
Done writing partition. Write speed: 777.07 KB/s
Writing DL_Info...
Writing DL_Info done
Partition PROTECT_F : formatting as EXT4. Please wait ...
Formatting completed
Partition PROTECT_S : formatting as EXT4. Please wait ...
Formatting completed
Writing eMMC Register ...
Reg: 179 Value: 0x48
Reg: 177 Value: 0x00
Reg: 162 Value: 0x01
All done time: [01:06:28:876]
HiPower mode is ON
Setting frequence to 7 MHz
CMD Pullup Level: 1701 mV
CMD Active Level: 1763 mV
EMMC Device Information :
EMMC CID: 150100464E31324D42002DD1555491C0
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacture : SAMSUNG , EMMC NAME: FN12MB , HEX: 464E31324D42 , S/N: 2DD15554 , rev. 0x00
EMMC Manufacture ID: 0x15 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Date: 9/2014
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 KB (000000080000) Counter: 0 , Response: Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: FN12MB_2DD15554_20201014_000740.extcsd
EMMC Init completed.
Get firmware version
Brand = HUAWEI
Manufacturer = HUAWEI
Device = HWCUN-U6582
Model = HUAWEI CUN-U29
Phone platform = mt6582
CPU Abi = armeabi-v7a
Mediatek platform = MT6582
Android release = 5.1
Security Patch = 2017-03-05
Firmware version = CUN-U29C567B134
Firmware date = Thu Apr 13 14:55:51 CST 2017
HiPower mode is ON
Setting frequence to 7 MHz
CMD Pullup Level: 1711 mV
CMD Active Level: 1753 mV
EMMC Device Information :
EMMC CID: 90014A483847316505075819AE4834B8
EMMC CSD: D02701320F5903FFFFFFFFEF8A4040D2
EMMC Manufacture : SKHYNIX , EMMC NAME: H8G1e , HEX: 483847316500 , S/N: 5819AE48 , rev. 0x07
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 3/2017
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000) Counter: 0 , Response: Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: H8G1e_5819AE48_20201014_004510.extcsd
EMMC Init completed.
Get firmware version
Brand = HUAWEI
Manufacturer = HUAWEI
Device = HWCUN-U6582
Model = HUAWEI CUN-U29
Phone platform = mt6582
CPU Abi = armeabi-v7a
Mediatek platform = MT6582
Android release = 5.1
Security Patch = 2017-03-05
Firmware version = CUN-U29C567B134
Firmware date = Thu Apr 13 14:55:51 CST 2017
pls help on how to solve .Thank you
