Samsung G600FY Dump Needed

Ashok madivala

Active Member
May 1, 2017
20
3
kundapura
Setting frequence to 21 Mhz
CMD Pullup Level: 2072 mV
CMD Active Level: 2887 mV
EMMC Device Information :
EMMC CID: 150100514E31364D4200960BDC55A20E
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacture Name: SAMSUNG , EMMC NAME: QN16MB , EMMC NAME (HEX): 514E31364D42 , S/N: 960BDC55 , rev. 0x00
EMMC Manufacture ID: 0x15 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Manufacture Date: 10/2015
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 KB (000000080000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x00 , Boot from: no boot
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: QN16MB_960BDC55_20181220_132011.extcsd
EMMC Init completed.

Scanning soft partitions
Partition table not found

Get firmware version
Firmware info not found
 
  • Like
Reactions: bobo7
Top